are they easy to adjust, need a lot of tools? thanks

------------------
Naples Gold Metallic 2000 3.2 TL
Wings West Kit Type-W
Comptech Exhausts
INSPIRE Tails
Cleared Out Custom HID's
00BMW Sidemarker DRLights
Custom Grill

 

naa.... at most all you need is a special wrench to turn the spring perch if it can't be turn by bare hands...

 

I have the apex coilovers and the rear is a pain in the ass for me to adjust. But then again I have a big ass box that weights the back ot the car down like a *****.

------------------
WW Type-W kit molded to stock kit_Custom clear headlights_Inspire taillights & trunk badge_18x7.5 RaptorRacing MZ-1_CP Polished coldair induction system_Custom painted engine panels_Alpine CVA-1005_PS2_Eclipse 15" sub_PPI 2400 & 4400 amps

 

use the special wrench to adjust

how long does it take you to adjust all four InspireFreak?

------------------
00' Acura 3.2TL Nighthawk Black Pearl
- 18's Lowenharts LGM Chrome (3 piece)
- 225/40 NT555
- Factory Kit
- Factory Spoiler
- Apexi N1 WS coilovers

 

It depends on how much i want to change it. about 15-60 min( the higher i go in the back the harder it is to turn the rear springs



------------------
WW Type-W kit molded to stock kit_Custom clear headlights_Inspire taillights & trunk badge_18x7.5 RaptorRacing MZ-1_CP Polished coldair induction system_Custom painted engine panels_Alpine CVA-1005_PS2_Eclipse 15" sub_PPI 2400 & 4400 amps

 

I have the Apexi Coilovers and it comes with its own special wrench to adjust the height. I haven't adjusted it yet but heard it wasn't that hard. Just use their special wrench to turn the screw to adjust the height and tighten it with another screw on the bottom. I will let you know once I adjust my height. But if anybody else does it before, please post instructions. Thanks.

------------------

 

iit's not hard to adjust,(just hard for me becuz of the sub box), just set the wrench in the noches of the smaller ring and loosen it. Then you can screw that down with your fingers. After that do that same to the bigger ring, that holds the spring, and like any other screw clockwise to raise and counterclockwise to lower. If the rear of your car is heavy like mine then you'll have keep raising it even though it's already compress to get your car even height. If you have any questions just pm or email me and Ill help.

 

i found out that if you jack up both sides of the rear or front at the same time, it makes adjusting the coilovers MUCH easier...so try that

 

Thanks for the advice fellas.

 

i have custom drop zone coil overs and it took me 25 minutes to jack up the car change all four wheels and put the coil overs to it's highest setting in about 25 min.

 

yeah adjust up on the coils is hard..

inspire you can adjust it by hand?.. man i tried that.. it didn't even budge.. maybe mine aren't broken in yet.. i dunno.. took me a good 15-20 mins per wheel..

slammed99TL.. how much where you coilovers? dayem you can adjust your quick

------------------
00' Acura 3.2TL Nighthawk Black Pearl
- 18's Lowenharts LGM Chrome (3 piece)
- 225/40 NT555
- Factory Kit
- Factory Spoiler
- Apexi N1 WS coilovers