Video of my car accelerating...
#1
Video of my car accelerating...
Guys. I took a video today of the tach/speedo from about 10mph to about 90mph. The 1st to 2nd shift wasn't the greatest (RPMs dropped a bit too much), but you can see the car lose traction in 1st, 2nd and a very poor 3rd gear chirp. You can see the car pulls very hard from 6K to 7.5K.
Basically... had the car rolling around 10mph and then slowly floored it. It's a little bumpy cuz I was holding the camera AND steering wheel with my left hand while shifting with my right
Now I need someone to host it... only 250KB (low res).
Exhaust is stock with the catalytic convertor... so it isn't as quick as I hoped it would be.
Basically... had the car rolling around 10mph and then slowly floored it. It's a little bumpy cuz I was holding the camera AND steering wheel with my left hand while shifting with my right
Now I need someone to host it... only 250KB (low res).
Exhaust is stock with the catalytic convertor... so it isn't as quick as I hoped it would be.
#5
allmotor,
if its only 250 kb, i will be glad to host it. i have about 1500 mb worth of transfer left for the month so it would be cool. email it to me at power3dfx@hotmail.com
i will host it and then post a link in this thread.
if its only 250 kb, i will be glad to host it. i have about 1500 mb worth of transfer left for the month so it would be cool. email it to me at power3dfx@hotmail.com
i will host it and then post a link in this thread.
Trending Topics
#14
The video will probably be up in the morning... Scrib is probably asleep right now (east coast).
Mods: Custom CAI, extrude-honed & ported intake manifold, billet TB, Comptech Header, UR Pulleys, Comptech Clutch/Flywheel.
You'll notice the RPM's drop quickly between shifts.... ala flywheel.
Mods: Custom CAI, extrude-honed & ported intake manifold, billet TB, Comptech Header, UR Pulleys, Comptech Clutch/Flywheel.
You'll notice the RPM's drop quickly between shifts.... ala flywheel.
#30
We need to get someone to make these ITB's for the V-6. http://www.honda-tech.com/zerothread?id=608338
#37
yeah, that's pretty typical when flooring 6speeds with power up in the power band. Mine is pretty bad as well. 1st gear is pretty bad without headers. I want to get them in the worst way but my fear is that i'm just going to loose more traction lower in the RPM range.