I still havent installed mine, How is everyone's headers doing so far.

 

Have more then one or two people even had them long enough to be considered long term?

 

myself and bulldog01 have them since September 02. No issues for me.

 

oct 03 about 15k miles, only problem was the rubber on lower hanger was over streched and has since broke. I really don't know their on there until I venture into "V" tech land.

 

So I guess I should just put them on?

I just had the headers cleaned up on the inside by one of the major race engine manufacturers / car owner shops (roush)

So, I should be good to go,,,,,


:jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2: :jump2:

 

i also purchased sr headers with last years g/b, not yet installed. main (top) flanges slightly warped. i sent out to machine shop to straighten then off to jet hot for inside / outside coating then back to me for diy install. (i'm going to test fit prior to shipping for coating process) after install will post results

 

How did you know they were warped??

 

I had mine installed in March '03, so it's been just about a year. I haven't had any problems. There was a resonance at various RPM, but I haven't noticed it in months. I think I may have a leak, but I haven't checked it closely enough. I kinda don't wanna check, ya know? I have, however, recently heard twice a rattling coming from near the cat, but I haven't checked it...too lazy. I've only heard it when walking to the car after it has been warming up for ten or fifteen minutes.