well i finally got to puttin on my camber kit and gettin my car aligned, but now i need to roll my fenders, anyone in the bay area know how to do this? my tires rub pretty bad. so i had to adjust my coilovers up.

 

ok again with this fender rolling thing... I'm not sure what ppl are talkinga bout with some fender rolling tool..

we used to just use an aluminum bat and "roll" it alon the fender so that it would curl in. on my rear wheels of my civic I used a small dremel tool and cut out the inner part of the fender where it rubbed. was really careful so paint dind't crack around it. basically the same thing ppl used to do to put in JDM sidemarkers to a USDM fender on the civics/integras etc...

 

i know theres no particular tool, i seen it done with the baseball bat, but i dunno how to do it myself..

 

if you're in Cali I wouldn't mind helping you do it. I'm here in SoCal until Mid August.

 

There is a Fender Rolling Tool, but it costs around $500

Tool

 

My last car was slammed - I just cut the inside of the fender into 1" sections with a metal cutter, and then hammered the sections up. Cutting the metal first prevents warping.

Yeah this way is kinda ghetto - but it cost my $0.00 and took me half an hour

 

hm ill try the baseball bat. forget the tool

 

be careful when you're rolling it back not to crack the paint and fuck it all up...do it a bit at a time.