amateur 1/4 mile run :)
#1
amateur 1/4 mile run :)
I aquired an OBDII interface adapter and Digimoto software for it. So besides reading and clearing computer codes it also reads a bunch of other data as well as calculates 0-60, 1/8, 1/4 and the dyno is also available but for some reason the program kept crashing on me while trying to do a dyno run.
So I did a couple runs and the best one was...
1/4: 14.6s @ 156Km/h (97.5 miles)
0-60: 6.2s
Mods: just an icebox with K&N filter, denso plugs and suspension. Plus a had a friend with me who was holding the laptop and a full trunk of tools (good 150lbs of stuff)
Looking at the 6.2 figure and comparing to stock 6.4 I guess Icebox does help a little. But considering I can get rid of my friend and get the trunk cleared I could probably do a bit better.
After reading a few posts I guess that sounds about right. So you think this could be considered an accurate reading?
So I did a couple runs and the best one was...
1/4: 14.6s @ 156Km/h (97.5 miles)
0-60: 6.2s
Mods: just an icebox with K&N filter, denso plugs and suspension. Plus a had a friend with me who was holding the laptop and a full trunk of tools (good 150lbs of stuff)
Looking at the 6.2 figure and comparing to stock 6.4 I guess Icebox does help a little. But considering I can get rid of my friend and get the trunk cleared I could probably do a bit better.
After reading a few posts I guess that sounds about right. So you think this could be considered an accurate reading?
Thread
Thread Starter
Forum
Replies
Last Post
mada51589
3G TL Problems & Fixes
79
05-03-2022 08:54 PM
jamestheunderdog
3G TL Problems & Fixes
11
07-19-2016 07:58 PM