tsxgoodfella

Wondering if there are any Halo eyes or Demon Eyes kit out on the market for the TSX or in the near future, i think it would be a sick look for the car. Also, are there any eye lids for the TSX?

Canyonball

I've seen an angel eyes-like mod, it was on aome JDM Euro R site. I think it was a LED fab'd into the housing, looked good...

I dunno about eye lids, I think the factory housing looks good...

PixelHarmony

I don't think our car really needs eyelids since it's like one of the lowest profile headlights, next to the TL. Angel eyes.. doubt it'll look that great on our car, I think it doesn't look good on anything but a BMW.

Chris_F

i'm attempting to do a DIY of this sometime in the near future - i'll post up pics and some instructions when i'm done - hopefully i can get it to work

MyK24a

any pics on the angel eyes mod on other cars?

nitehawktsx67

dam i wish there was a kit for angel eyes i love the look of them on bimmers, umm try looking on e46fanatics.com there should be some pics of them there

jester2

Actually, this has been discussed in a previous post. Someone in Japan did it on their Euro-R station wagon.

http://homepage3.nifty.com/garage999/manager.htm

It's pretty effin sweet. Looks like a pissed off cat for sure.

dondon

i made sumthing like this..... i just need to sand the edges and paint them......

MyK24a

Its not really that obvious though

arch

Check out the link to this thread where it has been discussed with a company that offers thier conversion services to most headlights. This is from the TL forums.

https://acurazine.com/forums/showthr...2&page=1&pp=25

PrecyseStylez

Yea..those angle/demon eyez look bad azz..if i wasnt in NJ i would send them a headlight to work on..i know there are alot of Cali guys that are members here..so go over there and get this project started!!

Stokeless_TSX

I like how the ring on the high beams is just kinda there...makes the car look alive where can i get those?

Chris_F

wire 3 small led's up per housing facing in all different directions then put the stock bulb back in (with thin wires it should still fit) and their light will catch the little notches of the reflector.

omelette

I emailed üm•nitza (the same people from that TL link) and this is what they had to say

Stokeless_TSX

umm so thats it? 3 lil LED's will make that entire ring around the housing?

Chris_F

yep, when i've finsihed doing it myself i'll post pics. it's how the japanese guys have done it. if u look closely at all the pictures you can see a bit of light being emmited from the centre and thats the led's. getting them in the right position and wiring them up so they don't melt or blow will be the tricky part.

Stokeless_TSX

make sure you do a write on a how too hehe