Need Help putting in my new intake...
#1
Need Help putting in my new intake...
hey guys had a questionf ro those out there who actually custom made their intakes... okay the directions said that i need a 3/8"OD rubber grommet... does anyone have any idea where i can find one... i remember someone recently putting in an intake for a 3.2... i will post pics after i install maybe this week during my spring break i will finish wiring my strobes and the intake should be in... later everyone...
#3
i was there man and they were like i don't think we have a universal grommet for what u need to do.. u can try the faucet dept and maybe u find a washer there.. i looked for an HOUR!!! nothing...
#5
couldn't find it again.. i was thinking about soldering on the nub... that should hold it.. or do u guys think that the solder will melt from the engine temp??? if not then i otta find a place that can weld it on for me...
Thread
Thread Starter
Forum
Replies
Last Post
SidhuSaaB
3G TL Problems & Fixes
18
05-30-2020 12:40 AM
LogicWavelength
3G TL Photograph Gallery
33
11-01-2015 09:38 AM