YL Al

guys my lower balljoint is not moving completely out as the top of the balljoint is slamming with the hub....i seen most have a dent in that area but this one looks factory and it seems that the balljoint was installed before the hub . what do i do, i have to use my car today and been hammering since 8 am but it keeps hitting and not going further.

Eband27

Hmm. I never changed a balljoint on a cl... Usually, there is a snap-ring that u should remove on hondas. Let me check my repair manual.

Eband27

http://www.mediafire.com/file/j111yzqz5dn/Balljoin remover.pdf

here, see if u can download that, i took a page out of the manual for the lower balljoint removal procedure. You are supposed to take the whole knuckle off the car, remove the bearing assembly, and then the balljoint will come out