What did you do to your RL today
#1
Thread Starter
Cruisin'
What did you do to your RL today
I have seen this on other forums...
I will start off...
Hooked up a Jet Tech FM transmitter - Works good
Put 2 new front rotors on and did a drain and fill of the trans fluid.
I will start off...
Hooked up a Jet Tech FM transmitter - Works good
Put 2 new front rotors on and did a drain and fill of the trans fluid.
The following users liked this post:
RL-Lover (04-23-2024)
#2
Are you asking about today today? If so, I opened the passenger door to get my sunglasses, and closed them
The following users liked this post:
rlx015 (07-15-2017)
#4
Replaced the driver's armrest with a new OEM armrest. Many, many screws to remove once the panel is popped.
(Last week replaced the glovebox, and then put a pad over the hole in my driver's floormat).
Will probably wash it today. And vacuum.
-R-
(Last week replaced the glovebox, and then put a pad over the hole in my driver's floormat).
Will probably wash it today. And vacuum.
-R-
#5
I'll throw few things I did lately
Installed Dashcam VOIFO A119s v2 and hid the wire, satisfied so far...
Installed microphone and hid the wire as well for BT45-ACU... resulting in static I was not able to get rid of. Not sure if it is the quality of the wire and mice OR interference by garage door opener perhaps...
Installed Dashcam VOIFO A119s v2 and hid the wire, satisfied so far...
Installed microphone and hid the wire as well for BT45-ACU... resulting in static I was not able to get rid of. Not sure if it is the quality of the wire and mice OR interference by garage door opener perhaps...
The following users liked this post:
rlx015 (07-24-2017)
Trending Topics
#8
Thread Starter
Cruisin'
Rob where did you get these and how much were they?
#10
The armrest was about $85. There's a youtube video of someone replacing just the armrest cover on the passenger side of their RL (about $40 for a pair of covers on ebay), but I thought it was worth the extra money not to have to peel off the old cover and glue/cut the replacement so I went for a the whole armrest unit instead to save time and not risk messing it up. If you're patient and industrious it might be worth it to go the cover route. I also couldn't be sure that flattened foam under a new cover wouldn't start to look bad or show over time.
After patching the hole in my floor mat, I figure I spent about $500 to restore my interior to almost new condition (and stop thinking about new cars).
Last edited by Rob144; 07-24-2017 at 09:45 AM.
#11
Thread Starter
Cruisin'
because they fell apart when I took the rear calipers off and to get them the same day.
Luckily I had another car to get to the parts store.
The following users liked this post:
JoeyD-RL08 (11-22-2020)
#14
[QUOTE=old_legend_guy;16058457]I have seen this on other forums...
I will start off...
Hooked up a Jet Tech FM transmitter - Works good
I'm about to pull the trigger on the transmitter, haven't had much success with these things but the reviews seem to say that this is the best one.
I will start off...
Hooked up a Jet Tech FM transmitter - Works good
I'm about to pull the trigger on the transmitter, haven't had much success with these things but the reviews seem to say that this is the best one.
#17
Thread Starter
Cruisin'
[QUOTE=Walfunk;16071461]There is static when music isn't playing, but for the price it will do for now.
#19
Hey Rob, new (to me) 2006 RL owner here. The center armrest is in rough shape, and I see where I can purchase the leather covers for some DIY, but I'd just as soon replace them altogether. Any idea what the part # would be? All I can find is the part number for the entire armrest assembly, with the shocking price tag to go with it. I like the $85 you mentioned. I'm specifically looking for the light tan color. Thanks, Dan
#20
Hey Rob, new (to me) 2006 RL owner here. The center armrest is in rough shape, and I see where I can purchase the leather covers for some DIY, but I'd just as soon replace them altogether. Any idea what the part # would be? All I can find is the part number for the entire armrest assembly, with the shocking price tag to go with it. I like the $85 you mentioned. I'm specifically looking for the light tan color. Thanks, Dan
#21
@oldlegendguy! Rec'd the FM transmitter today and I must say I am very satisfied with the performance. I have NEVER had luck with these things; either a lot of static\interference or weak output. This one works superbly. A lot cheaper than having to get one of those USA Spec or Grom boxes and zero install issues. Now I can hear my music and podcasts via my phone once again. Thanks for creating this thread or I would have never considered it! I'm using 88.3 btw (maryland,de,pa areas)
Last edited by Walfunk; 08-07-2017 at 09:05 PM.
#22
Armrest
Dan, I'm not much help on that one because I only worked on the driver's door armrest. Back when the car was still under warranty, my center armrest went bad quickly enough that the dealer replaced it. I think there's some links here in the RL forum that probably have some ideas on the center armrest if not some high-level instructions. That would be one where I'd think the replacement covers would be low cost place start (with the necessary research to see how the console tops can be disassembled combined with your own comfort level on disassembling things in your new-to-you car).
#23
Moderator
iTrader: (2)
Changed my cabin air filter today... I'm always surprised how dirty it gets in a year. Anyone else have a cabin air filter that gets dirty in a short period of time on this car? No dirt roads at all, and every other vehicle in the household that has cabin air filters does NOT get this dirty lol
#24
Changed my cabin air filter today... I'm always surprised how dirty it gets in a year. Anyone else have a cabin air filter that gets dirty in a short period of time on this car? No dirt roads at all, and every other vehicle in the household that has cabin air filters does NOT get this dirty lol
#25
Used Poorboys World Wipe & Spray Waterless Wash + Blackfire Midnight Sun Instant Detailer to get this thing clean after all the rain we got yesterday.
Followed my brother in his '98 LS400 to a local car meet and had a pretty good time, we got out on the highway and did a few pulls from different speeds, it seems that his car is faster than the RL, my car didn't get left badly but he clearly had the edge, his car is lighter and has more torque so I'm not surprised. His car is bone stock "performance" wise other than a K&N air filter and resonator deletes.
Followed my brother in his '98 LS400 to a local car meet and had a pretty good time, we got out on the highway and did a few pulls from different speeds, it seems that his car is faster than the RL, my car didn't get left badly but he clearly had the edge, his car is lighter and has more torque so I'm not surprised. His car is bone stock "performance" wise other than a K&N air filter and resonator deletes.
#26
Ask not...
The following users liked this post:
projektvertx (09-02-2017)
The following users liked this post:
projektvertx (09-02-2017)
#32
Thread Starter
Cruisin'
Debating whether or not to pony up $175 for a trunk lid with a factory spoiler, it's the same color.
Hmmm worried there might be scratches or dings, it's at a junk yard so I don't think I can look at it
before I purchase it.
Hmmm worried there might be scratches or dings, it's at a junk yard so I don't think I can look at it
before I purchase it.
#33
Oh, what did I do to my RL today? Just tried to change the oil but it looks like the bolt is rounded. gonna havta to get it up on a lift, get it out and replace it. Any hints on getting out a stripped bolt?
#34
Moderator
iTrader: (2)
I installed morimoto motoho1ders on my retrofit. Also bought a new pipe to connect the airbox and the throttle. I bought a new driver door armrest, but it's from Delray Acura. It looks like it didn't make it out before Irma, so USPS delayed the shipment. Praying the people of South Florida stay safe!!!
#35
Thread Starter
Cruisin'
#37
Moderator
iTrader: (2)
Scratch that, that's a good deal then. I was under the impression it was for just the deck lid spoiler, not the whole deck lid with the spoiler lol. Good deal, I'd check it out! Worst case scenario you can pull the spoiler off and sell the deck lid, or get scrap metal value for it.