Mdx spacer question
#43
Im just curious how much it was to get it milled. trying to see how much cheaper it is to go to a junkyard is all......also wondering if you couldve gotten away with an inch instead of 3 quarters of an inch.
#45
Banned
Thread Starter
I paid about 75 it might depends on which shop you take it to. You can probably get away with 1 inch, p2r website says if you use the spacer with the 2 thermal gaskets total thickness would be one inch.
#46
Banned
Thread Starter
I unsuccessfully tried to install the spacer yesterday. The tabs that hang off the side got in the way of the fuel rails and wouldnt sit completely flat...if i find the motivation to grind them off ill try again but i dont thinknthats going to happen oh well live and learn
The following users liked this post:
mattcl-s (07-24-2017)
#49
Banned
Thread Starter