AcuraZine - Acura Enthusiast Community - Search Results



Showing results 1 to 29 of 29
Search took 0.02 seconds.
Search: Posts Made By: totaledTL
Forum: Second Generation TL (1999-2003) 03-13-2016, 08:03 PM
Replies: 5
Views: 516
Posted By totaledTL
There are some at this site, and guides too. ...

There are some at this site, and guides too.

http://ledautomotive.com/category.php?id_category=15


LEDautomotive.com - 1999 - 2003 Acura TL & 2001-2003 Acura CL Installation Guides...
Forum: Second Generation TL (1999-2003) 01-09-2016, 10:41 AM
Replies: 40
Views: 2,024
Posted By totaledTL
That stinks, I hope the perp tripped & busted his...

That stinks, I hope the perp tripped & busted his face up.
Forum: 2G TL Problems & Fixes 02-05-2012, 09:26 PM
Replies: 6
Views: 1,430
Posted By totaledTL
Brake light filaments burnt out?

Brake light filaments burnt out?
Forum: Second Generation TL (1999-2003) 01-18-2012, 10:00 AM
Replies: 13
Views: 1,153
Posted By totaledTL
Or, the load (by design) is drawing more current...

Or, the load (by design) is drawing more current than the circuit and/or protection is designed to carry.

If I were you I would NOT use taps for anything that draws very much current- they are NOT...
Forum: Second Generation TL (1999-2003) 01-11-2012, 06:47 AM
Replies: 7
Views: 775
Posted By totaledTL
What exactly did you add to the vehicle's wiring,...

What exactly did you add to the vehicle's wiring, and how (schematic needed)? Hard to say without some details.

What happens if you disconnect one HID, then the other (reconn. the 1st one to...
Forum: 2G TL Problems & Fixes 01-09-2012, 06:58 AM
Replies: 7
Views: 878
Posted By totaledTL
This one is pretty useful: ...

This one is pretty useful:

https://acurazine.com/forums/showthread.php?t=706003&highlight=transmission+filter&page=3

Source:
...
Forum: Second Generation TL (1999-2003) 01-02-2012, 08:10 PM
Replies: 20
Views: 1,828
Posted By totaledTL
Well if you're going to take it upon yourself to...

Well if you're going to take it upon yourself to fix it how/why would you go after the seller then? :ponder: Makes no sense. You're screwing yourself if you don't pursue it right away. BTW, I...
Forum: 2G TL Problems & Fixes 12-19-2011, 09:21 PM
Replies: 34
Views: 37,337
Posted By totaledTL
Sorry, that's not good enough. You must verify...

Sorry, that's not good enough. You must verify continuity w/ an ohm meter if you really want to test them. There could be an open somewhere that is not visually evident. And if they aren't open they...
Forum: Second Generation TL (1999-2003) 12-16-2011, 10:51 AM
Replies: 17
Views: 2,244
Posted By totaledTL
Oh man, don't do it- get some ramps, they are...

Oh man, don't do it- get some ramps, they are cheap!
Forum: 2G TL Problems & Fixes 12-08-2011, 12:03 PM
Replies: 3
Views: 668
Posted By totaledTL
Do not forget to check the battery- low voltage...

Do not forget to check the battery- low voltage can cause wierd issues.
Forum: Second Generation TL (1999-2003) 12-03-2011, 09:03 PM
Replies: 24
Views: 2,870
Posted By totaledTL
Well if you think it's more dangerous w/ them...

Well if you think it's more dangerous w/ them enabled you can always disable them.

I'll take my chances with them working.
Forum: 2G TL Problems & Fixes 11-23-2011, 06:41 AM
Replies: 18
Views: 1,034
Posted By totaledTL
Sounds like one or both speed sensors is whacked....

Sounds like one or both speed sensors is whacked. I would first pull the wheels and inspect the sensors, wiring & sensor wheels. Look for any damage and make certain everything is securely mounted....
Forum: Second Generation TL (1999-2003) 09-25-2011, 08:33 PM
Replies: 13
Views: 2,645
Posted By totaledTL
If the bolt threads are trash use a dremel and...

If the bolt threads are trash use a dremel and just cut off the nut. If you think the bolt is useable use the dremel and cut grooves in the nut in the same plane (parallel) as the bolt and then use a...
Forum: 2G TL Problems & Fixes 08-26-2011, 02:19 PM
Replies: 26
Views: 56,526
Posted By totaledTL
It was not a driving lesson- surely you...

It was not a driving lesson- surely you understand that. I don't claim to be a saint by any stretch of the imagination, nor do I think I act like one. I never said anything like that.

What I have...
Forum: 2G TL Problems & Fixes 08-26-2011, 10:45 AM
Replies: 26
Views: 56,526
Posted By totaledTL
:thumbsdow You really should refrain from...

:thumbsdow

You really should refrain from doing that... esp. going 80 mph.... it's dangerous not only to you but fellow drivers. It's now illegal in KY. I don't know about other states.
Forum: 2G TL Problems & Fixes 08-15-2011, 10:40 AM
Replies: 12
Views: 984
Posted By totaledTL
If the temp. rose that high I would have it towed...

If the temp. rose that high I would have it towed rather than take a chance driving it, assuming it will start. If you ever notice the temp. rising like that, shut off the engine immediately....
Forum: 2G TL Problems & Fixes 07-28-2011, 06:58 AM
Replies: 24
Views: 1,684
Posted By totaledTL
Inspect the wiring to the sensor for damage-...

Inspect the wiring to the sensor for damage- interm. shorting to gnd?
Forum: 2G TL Problems & Fixes 07-10-2011, 09:13 PM
Replies: 2
Views: 492
Posted By totaledTL
Oops just saw this is a dup. thread. :lock: ...

Oops just saw this is a dup. thread. :lock:

https://acurazine.com/forums/showthread.php?p=13080442#post13080442
Forum: 2G TL Problems & Fixes 07-10-2011, 08:35 PM
Replies: 2
Views: 492
Posted By totaledTL
Did you read the DIY? Probl. a large impact gun...

Did you read the DIY? Probl. a large impact gun is the easiest way to do it. There's a special tool for that also.
Forum: 2G TL Problems & Fixes 07-06-2011, 10:21 PM
Replies: 24
Views: 19,352
Posted By totaledTL
Def. junk yd. run in order. See if there is a...

Def. junk yd. run in order. See if there is a Pull-a-Part near you (cheap). It looks like it would be easier to do what 01tl said or barring that cut & inline splice (ea. wire) on either side of the...
Forum: Second Generation TL (1999-2003) 06-30-2011, 02:14 PM
Replies: 31
Views: 1,182
Posted By totaledTL
You can't tell if they are dragging? 1....

You can't tell if they are dragging?

1. Drive, at least 10 min. or so then stop. Go around & put your hand near ea. wheel to chk. for excessive heat; make relative comparisons.

2. Find a very...
Forum: 2G TL Problems & Fixes 06-06-2011, 09:56 PM
Replies: 30
Views: 2,040
Posted By totaledTL
Way more details/pics needed. Pls. try to avoid...

Way more details/pics needed. Pls. try to avoid the run on sentences- it makes it harder to understand your problem. It obviously IS damaged or it would not be leaking & failing to pull itself.
...
Forum: Second Generation TL (1999-2003) 06-06-2011, 09:47 PM
Replies: 12
Views: 662
Posted By totaledTL
???????????

???????????
Forum: 2G TL Problems & Fixes 02-15-2011, 09:09 AM
Replies: 12
Views: 2,587
Posted By totaledTL
Sounds like ign. switch failure, commonly...

Sounds like ign. switch failure, commonly reported on 99s. Chk. the DIY section and search, you will find plenty of info.
Forum: 2G TL Problems & Fixes 12-06-2010, 01:45 PM
Replies: 8
Views: 4,402
Posted By totaledTL
How old is your battery? Is it sealed or can add...

How old is your battery? Is it sealed or can add (distilled) water if needed? Any corrosion on the terminals? Had it load tested?

When it's cold out people are going to let them idle to warm-...
Forum: Second Generation TL (1999-2003) 10-06-2010, 02:25 PM
Replies: 23
Views: 2,229
Posted By totaledTL
Spend a little time searching this forum. There...

Spend a little time searching this forum. There is a lot of good information on this very topic. It's a common issue. And welcome-
Forum: 2G TL Problems & Fixes 10-05-2010, 12:07 PM
Replies: 30
Views: 7,594
Posted By totaledTL
This I witnessed recently on another car- weak...

This I witnessed recently on another car- weak battery intermittently caused fuel cap light, brake light & 1 other one (I forget which one) to come on. Also the power windows would become inop. even...
Forum: 2G TL Problems & Fixes 03-12-2009, 06:42 AM
Replies: 22
Views: 32,333
Posted By totaledTL
Nice work, thanks for taking the time to post...

Nice work, thanks for taking the time to post this. Ever tested/replaced any defective parts in the inverter to get one working?
Forum: 2G TL Problems & Fixes 11-16-2008, 02:42 PM
Replies: 34
Views: 37,337
Posted By totaledTL
If the element is burnt in more than one place...

If the element is burnt in more than one place like mine was you can get replcmt. elements at http://www.heatedseatkits.com/ for much less & they're a better design.
Showing results 1 to 29 of 29

 
Forum Jump

All times are GMT -5. The time now is 07:47 AM.