AcuraZine - Acura Enthusiast Community - Search Results

Notices
 
Search: Posts Made By: TSX1012m6
Showing results 1 to 40 of 47
Search took 0.38 seconds.
06-03-2019, 01:28 PM
Replies: 13
Views: 1,344
Posted By Margaret Thompson

Thank you thank you thank you! I have been...

Thank you thank you thank you! I have been looking for this service bulletin all morning! Dealer fixed once and trim flew off again 4 years later. I am going to do the repair and needed this. :)
05-20-2018, 01:13 PM
Replies: 10
Views: 834
Posted By BROlando

repeated gear slamming in a car with a huge delta...

repeated gear slamming in a car with a huge delta from 1st to 2nd gear...and a clutch setup that engages close to the floor is a recipe for worn synchros.

This isn't a "performance"...
05-17-2018, 10:04 PM
Replies: 10
Views: 834
Posted By BigBuffetPocket

Sorry been a little busy. But here's a pic of how...

Sorry been a little busy. But here's a pic of how messed up the bearing was and what it should look like....
05-14-2018, 11:20 PM
Replies: 3
Views: 930
Posted By frice

OEM Wiper Blade Refills

Hi, I just signed up to pass something along that might help a 2G TSX owner. If you still have your original hard plastic wiper blades which use 10m thick replacement rubber refills, you can only get...
04-10-2018, 12:16 PM
Replies: 8
Views: 460
Posted By justnspace

you're looking for what is called an "axle back" ...

you're looking for what is called an "axle back"

if a full cat back is everything from the cat and back....the axle back would be everything from the rear wheels and back.
unfortunately, not a...
02-27-2018, 10:21 AM
Replies: 24
Views: 2,182
Posted By horseshoez

I third the motion; when I bought my 6MT last...

I third the motion; when I bought my 6MT last may, third gear was both notchy and would pop out on occasion. A change to ACDelco Synchromesh Friction Modified cured the issue immediately.
02-27-2018, 10:09 AM
Replies: 24
Views: 2,182
Posted By justnspace

^the one you linked is the one I use. fixed my...

^the one you linked is the one I use. fixed my 3rd gear pop out.
02-27-2018, 10:08 AM
Replies: 24
Views: 2,182
Posted By thoiboi

IF 6MT, GM FM Synchromesh, If Auto, Honda. ...

IF 6MT, GM FM Synchromesh,

If Auto, Honda.


/endthread.
02-07-2018, 10:47 AM
Replies: 18
Views: 956
Posted By justnspace

fellas, he's talking about following old stinky...

fellas, he's talking about following old stinky school buses/Fire engines/old pieces of shit cars.
while following behind these cars, he can smell their exhaust gasses.

P.S. a Fire engine pulled...
01-12-2018, 12:24 AM
Replies: 57
Views: 14,061
Posted By KrylonBlue

Iím not sure yet because itís been in the 40s and...

Iím not sure yet because itís been in the 40s and 50s so the battery wouldnít be strained due to the cold weather. But Acura did tell me the new unit is drawing 0ma when shut down compared the 220ma...
11-09-2017, 08:27 AM
Replies: 8
Views: 5,200
Posted By xtcnrice

You can hear it inside. It lasts for about a...

You can hear it inside. It lasts for about a second for me. There is no known fix for this issue at the moment by the way. Dealership will replace your VTC actuator with the same part, and the issue...
10-18-2017, 01:32 PM
Replies: 11
Views: 2,863
Posted By BROlando

245/45 is closer to the stock diameter. I'd...

245/45 is closer to the stock diameter. I'd probably go with that.
08-30-2017, 08:45 AM
Replies: 5
Views: 1,558
Posted By Rebound

Arrow Honda Accord CU3 CU2 Europe 2008 - Sunny Lisbon

Hello everyone. :good:

My name is Ricardo and i am from Portugal - sunny Lisbon.
I own a Honda Accord CU2 since 06/2008 (when the 1st ones came out). One of the local Honda dealers had a typo...
08-15-2017, 09:05 PM
Replies: 24,768
Views: 976,621
Posted By MC MiYoung3269

It'll work. The car will re learn itself once you...

It'll work. The car will re learn itself once you drive a bit.
07-24-2017, 01:31 PM
Replies: 62
Views: 8,879
Posted By Cristian Loza

A lot of updates since my last post. My seats...

A lot of updates since my last post. My seats finally came in (not installed yet.. been super busy!) and I got my headlights and tail lights from Ratchet Racing in and installed. I will post more...
07-20-2017, 04:46 PM
Replies: 5
Views: 554
Posted By 01acls

The specs look fine to me. According to the specs...

The specs look fine to me. According to the specs the frame is not bent. If your car was in an accident it's been repair correctly.

Given the low mileage on your car I can't see wear being an...
07-14-2017, 11:26 AM
Replies: 8
Views: 462
Posted By justnspace

certainly the case for my TL. I think mine failed...

certainly the case for my TL. I think mine failed before 60k miles. (although, my driving habits, or abuse, might have contributed to them dying. 6MT and I drive like i stole it.)

the automatic...
07-14-2017, 11:25 AM
Replies: 8
Views: 462
Posted By thoiboi

Sure. It's rubber after all . Best way...

Sure. It's rubber after all .



Best way to check mounts is to have the hood up, e brake on with foot on pedal, have someone stare at engine while you shift from P to R to D. Look for excessive...
07-14-2017, 11:22 AM
Replies: 8
Views: 462
Posted By justnspace

I dont have a TSX, so I dont know what they look...

I dont have a TSX, so I dont know what they look like.
for my TL, I could see one "limping and dangling" and the others i had to take a cover off to inspect if rubber is still intact.
07-13-2017, 06:33 AM
Replies: 10
Views: 4,386
Posted By justnspace

yikes, sounds like you bought a fucked up car. ...

yikes, sounds like you bought a fucked up car.
with the limited amount of info you gave, the only thing i can think of is...look at the fuses. check to make sure all fuses are intact.
07-02-2017, 12:11 PM
Replies: 3
Views: 1,347
Posted By 01acls

There are various things you can try but the...

There are various things you can try but the simplest it to raise the front Hood stoppers. Although if your hood is vibrating by the windshield then that is a harder problem to solve.

Front Hood...
06-25-2017, 08:38 PM
Replies: 15
Views: 1,063
Posted By JayhawkRX

Just wanted to thank everyone for the advice!...

Just wanted to thank everyone for the advice! After test driving them all, decided to go with the 2013 TSX SE. Excellent condition and super clean .I've already got lots of mods in mind, too. :yum:
...
06-21-2017, 11:52 PM
Replies: 83
Views: 6,313
Posted By skathe

dude hurrry up lol

dude hurrry up lol
06-01-2017, 08:14 AM
Replies: 4
Views: 1,807
Posted By hammerx

RDX Wheels with 245/40/19

Hey everyone. Had my TSX for about four years and bought these RDX wheels as soon as I purchased the vehicle. I told myself I'd wait until the factory tires needed replacing, and 55K miles later it...
05-29-2017, 05:08 PM
Replies: 28
Views: 1,105
Posted By briq456

Current status. Went to visit her in the ER. ...

Current status. Went to visit her in the ER.
https://cimg2.ibsrv.net/gimg/acurazine.com-vbulletin/2000x1504/80-img_2311_113d54eee80a465a93969457718f24f5e6106a37.jpg...
05-15-2017, 05:37 PM
Replies: 16
Views: 1,663
Posted By opboarding

Here you go, trim removal DIY. ...

Here you go, trim removal DIY.

https://acurazine.com/forums/second-generation-tsx-discussion-2009-2014-143/diy-trim-removal-857830/
05-15-2017, 07:40 AM
Replies: 16
Views: 1,663
Posted By thunderbt3

There were darker trim pieces offered as an...

There were darker trim pieces offered as an accessory. The install instructions should come in handy for you.

http://techinfo.honda.com/rjanisis/pubs/AI/BII39133.pdf

If you can't open it, try...
05-12-2017, 03:58 PM
Replies: 16
Views: 1,663
Posted By TacoBello

Here's an example of a brushed metal wrap. You...

Here's an example of a brushed metal wrap. You can get them in different colors, too. Personally, I think this looks pretty sharp and very OEM-like. For the price, it's a good alternative.
...
05-04-2017, 11:11 PM
Replies: 17
Views: 2,057
Posted By BROlando

I dont see why 225/50's won't work on a 8" wide...

I dont see why 225/50's won't work on a 8" wide wheel....
05-04-2017, 03:23 PM
Replies: 13
Views: 2,683
Posted By BROlando

^dammit. the first sentence should read 32F or...

^dammit. the first sentence should read 32F or 0C.

Also, your Pontiac was likely designed to run on 10W30...but they felt 10W30 was too thick for winter starts, so they spec'd a 5W30 for winter.
...
05-04-2017, 03:04 PM
Replies: 13
Views: 2,683
Posted By BROlando

0W or 5W is what the oil starts out as from 0F...

0W or 5W is what the oil starts out as from 0F til about at around room temp (approx 65F or 70F, IIRC).

For example...a 0W30:
-Will flow like a 0Wt at cold temps.
-Will flow like a 30Wt at...
05-04-2017, 12:46 PM
Replies: 13
Views: 2,683
Posted By BROlando

??

??
02-13-2017, 01:09 PM
Replies: 2
Views: 398
Posted By robpp

first of all the front bumper may have been...

first of all the front bumper may have been removed but the grille is attached to the bumper. they come off as one piece.
there are lots of plastic clips back there.
they could have POPPED out...
02-13-2017, 01:06 PM
Replies: 2
Views: 398
Posted By thoiboi

May have hit something, You can probably pop it...

May have hit something, You can probably pop it back in if you disassemble the bumper.
02-10-2017, 09:53 AM
Replies: 25
Views: 1,117
Posted By MCDavis

To my knowledge, no, they should fit. Is there...

To my knowledge, no, they should fit. Is there something that makes you think otherwise?



The problem with any LED or HID bulb is that the focal point of the light output is likely in a...
02-10-2017, 09:49 AM
Replies: 25
Views: 1,117
Posted By Comfy

I've put the similar high powered LED lights in...

I've put the similar high powered LED lights in my 2008 Civic with absolutely no issues for installation. Yes the light output is not ideal with plenty of hotspots and dead spots/ weird patterns...
01-13-2017, 07:04 PM
Replies: 23
Views: 2,390
Posted By aquasurf

As a car engineer I would like to comment on...

As a car engineer I would like to comment on Honda/Acura 4-cylinder engines, particularly the TXS engine (K24). Honda engines with VTEC are by design high-revving engines producing max. power at 7K...
01-12-2017, 01:05 PM
Replies: 8
Views: 625
Posted By cu2wagon

It can be cut no problem. It *should* be...

It can be cut no problem.

It *should* be possible to register it to the car ECU as long as it's got the same FCC ID code. That is, Honda uses a wide range of transmitter IDs/wavelengths and you...
01-11-2017, 10:15 PM
Replies: 8
Views: 625
Posted By cu2wagon

Yup. eBay is probably the place you need....

Yup.

eBay is probably the place you need. You can find all sorts. As long as you can find the same switchblade key style, you can disassemble it and swap the parts over.

There are OEM as well...
12-24-2016, 02:27 PM
Replies: 97
Views: 16,952
Posted By Username 0

Got the accord v6 tie down plate and perfect fit....

Got the accord v6 tie down plate and perfect fit. I used the 4cyl J-rods (195mm or 7.5in in length). So if you go my route, you just need the battery and the plate. ...
Showing results 1 to 40 of 47
 


 
Forum Jump

Contact Us - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.