Subaru front lip
 

https://cimg1.ibsrv.net/gimg/acurazi...ea4cf77d24.jpg
Finally got around to installing the Subaru lip I've had in the garage for a couple months. Next up is wrapping the grill and door pillars in gloss black vinyl.

Have any Under mounting pics? How much did you have to trim of each side?

I didn't have to trim the sides at all but I accidentally cut the top of the middle so I ended up cutting about a inch off the top. It sits way higher now but I had to mount it in a different way. I put screws straight through the front right in to the front of the black middle bummer trim. I am going to take the piece I cut off and use it to cover where u can see the screws in the front.

what kind of screws did you use to hold it up?

Sounds like they'res minimal modificaiton to the splitter required?

WOuld like to do this but don't want to butcher the splitter

Anyone with a 2013-2018 ILX thinking of doing this splitter mod to their vehicle (and live in the Greater Vancouver area) I have one that I never installed and is just sitting around in my garage.

:thumbsup:

i would be interested but im all the way in toronto

Poonasor I sent you a PM - This is not my thread so I did not want to comment too much here.

So this is the same fitment for the 17-18 ILX too?

Yes, it will fit both generations

Where did you buy this lip?

PureZ,
I purchased it a few years ago online, I am sorry I can not remember where? I live in Vancouver, BC Canada. Where are you? If anyone lives close enough they can have it for free. My only condition is that they have to pick it up, and post a picture once it's on! I never got around to it.

Chrifff

I put one on my '16 A-Spec and wasn't well pleased with it.


https://cimg7.ibsrv.net/gimg/acurazi...1a8a9aaf7.jpeg

I replaced it with the A-Spec underbody spoilers.


https://cimg2.ibsrv.net/gimg/acurazi...f18bcab90c.jpg