civicdrivr's golfcart and Z8 - 5 thread
#5041
Chapter Leader (Southern Region)
the lesbaru, like a hair pie
of ass
of ass
#5043
Whats up with RDX owners?
Thread Starter
iTrader: (9)
I was referred to a shop that's about an hour away that specializes in VWs (they must stay busy ). They quoted me $650 for the clutch install and stated it typically takes them about 6hrs to do an AWD clutch. So I'm going to have them do it and I'll hold off on the lift until my bonus comes in in February.
I also ordered:
- Black Forest Industries stage 1 (70A durometer) engine mounts; this also came with a dogbone mount insert, but I already have one so I'll sell this one
- iABED rear main seal (everyone swears by this one)
- Fluidampr; the single mass flywheels are pretty noisy, and this is supposed to help
This should hold me over for a year or so; at least until the fuel system parts go on sale, and then I'll probably upgrade the turbo. I'm hoping to the have that stuff in the car before the new year because the OEM clutch does not like anything above 50% throttle in the midrange
I also ordered:
- Black Forest Industries stage 1 (70A durometer) engine mounts; this also came with a dogbone mount insert, but I already have one so I'll sell this one
- iABED rear main seal (everyone swears by this one)
- Fluidampr; the single mass flywheels are pretty noisy, and this is supposed to help
This should hold me over for a year or so; at least until the fuel system parts go on sale, and then I'll probably upgrade the turbo. I'm hoping to the have that stuff in the car before the new year because the OEM clutch does not like anything above 50% throttle in the midrange
#5044
Azine Jabroni
The weekend after Thanksgiving is always an expensive one for car guys... i'm waiting for these to come in from ze Fazzahland:
I got them for a steal - the best price I've seen was $750 with harness; I paid right around $550 for them shipped, and about $99 for a used harness from ShopDAP (it was either used on one of their demos or an mk7 owner accidentally ordered it a returned it). I'm looking forward to getting them, but not necessarily the install. Routing the wiring through the rubber boots at the top of the hatch is a pain.
I also ordered the DKM twin disc clutch and light weight flywheel, since my clutch is slipping in the 3k rpm range when I give it more than half throttle (the stock clutch is notoriously weak). It's rated to hold 660ft-lbs of torque at the wheels, but I will never make that much power - at most, I'll be in the mid-400 range if I upgrade the turbo. I've been calling around to get quotes for the install, and shops are running anywhere from $900 to $1500 for the install, which is insane. I may use the install money to pick up a QuickJack and do it myself, but I'm waiting on a few other shops to get back to me.
I may also place an order on new motor mounts since I'll be in there anyway
I got them for a steal - the best price I've seen was $750 with harness; I paid right around $550 for them shipped, and about $99 for a used harness from ShopDAP (it was either used on one of their demos or an mk7 owner accidentally ordered it a returned it). I'm looking forward to getting them, but not necessarily the install. Routing the wiring through the rubber boots at the top of the hatch is a pain.
I also ordered the DKM twin disc clutch and light weight flywheel, since my clutch is slipping in the 3k rpm range when I give it more than half throttle (the stock clutch is notoriously weak). It's rated to hold 660ft-lbs of torque at the wheels, but I will never make that much power - at most, I'll be in the mid-400 range if I upgrade the turbo. I've been calling around to get quotes for the install, and shops are running anywhere from $900 to $1500 for the install, which is insane. I may use the install money to pick up a QuickJack and do it myself, but I'm waiting on a few other shops to get back to me.
I may also place an order on new motor mounts since I'll be in there anyway
The US one still has the sequential part but there's a light that blinks along with it.
#5045
Whats up with RDX owners?
Thread Starter
iTrader: (9)
I was planning on taking the car out to have some AWD fun last night in the 1-3" of snow we were forecast to get, but we got ~11" I can't even get out of my driveway The roads in my community are state roads, so we're waiting on VDOT to plow them, which probably won't happen until tomorrow or Wednesday
In other news, I got the Fluidampr, rear main seal, new crank pulley bolt and wiring for the Euro tails.. I'm still waiting on the clutch and mounts to ship, and the taillights are...somewhere. The DHL tracking was last updated on Dec 3 when it left Germany, and DHL says to get updates from USPS now, but USPS still says Pre-Shipment.
In other news, I got the Fluidampr, rear main seal, new crank pulley bolt and wiring for the Euro tails.. I'm still waiting on the clutch and mounts to ship, and the taillights are...somewhere. The DHL tracking was last updated on Dec 3 when it left Germany, and DHL says to get updates from USPS now, but USPS still says Pre-Shipment.
Last edited by civicdrivr; 12-10-2018 at 09:40 AM.
#5046
Ex-OEM King
No snow tires? I'd still be out trying to get stuck lol.
#5047
Whats up with RDX owners?
Thread Starter
iTrader: (9)
Yes and no lol. I have a set left over from the GTI that I thought were 17s, but they were 16s, so they won't clear the brakes on the R
#5049
Whats up with RDX owners?
Thread Starter
iTrader: (9)
#5050
Moderator
Regional Coordinator (Southeast)
Regional Coordinator (Southeast)
Join Date: Dec 2003
Location: Mooresville, NC
Age: 37
Posts: 43,472
Received 3,657 Likes
on
2,491 Posts
I was planning on taking the car out to have some AWD fun last night in the 1-3" of snow we were forecast to get, but we got ~11" I can't even get out of my driveway The roads in my community are state roads, so we're waiting on VDOT to plow them, which probably won't happen until tomorrow or Wednesday
In other news, I got the Fluidampr, rear main seal, new crank pulley bolt and wiring for the Euro tails.. I'm still waiting on the clutch and mounts to ship, and the taillights are...somewhere. The DHL tracking was last updated on Dec 3 when it left Germany, and DHL says to get updates from USPS now, but USPS still says Pre-Shipment.
In other news, I got the Fluidampr, rear main seal, new crank pulley bolt and wiring for the Euro tails.. I'm still waiting on the clutch and mounts to ship, and the taillights are...somewhere. The DHL tracking was last updated on Dec 3 when it left Germany, and DHL says to get updates from USPS now, but USPS still says Pre-Shipment.
#5051
Ex-OEM King
Not all 17" wheels will clear the brakes so make sure you do some research before you buy a set. I have the factory wheels off of a Jetta that I use that ever so barely fit. I think that even a couple post it notes would cause the wheels to hit the calipers.
Hard pass lol. FL heat and humidity is no joke.
We have no snow, it's just cold. Well we do have some but it's like 2in on the ground that never melts because cold. It's the gritty icy snow at this point.
#5052
Whats up with RDX owners?
Thread Starter
iTrader: (9)
I actually don't mind it. The humidity sucks, but to me, it's better then snow and cold.
The following users liked this post:
civicdrivr (12-10-2018)
#5054
Turd Polisher
iTrader: (1)
I had to put on a sweatshirt this morning .... I hate freezing weather
The following users liked this post:
ttribe (12-10-2018)
#5056
Whats up with RDX owners?
Thread Starter
iTrader: (9)
#5057
Ex-OEM King
#5058
Whats up with RDX owners?
Thread Starter
iTrader: (9)
Am I the only one walking around their house naked??
#5059
Moderator
What's all that white stuff? It looks like someone vandalized your house and cars, Morgan!
#5060
Senior Moderator
#5061
Team Owner
Damn... someone is ballin out of control with all that coke... White Christmas indeed!
The following users liked this post:
thoiboi (12-11-2018)
#5063
Whats up with RDX owners?
Thread Starter
iTrader: (9)
#5064
Chapter Leader (Southern Region)
11 inches you say
#5065
Whats up with RDX owners?
Thread Starter
iTrader: (9)
#5066
#5067
Senior Moderator
The following users liked this post:
rockstar143 (12-11-2018)
#5068
Whats up with RDX owners?
Thread Starter
iTrader: (9)
Dynamic taillights arrived yesterday, even though they've been in the states since Dec 7th I wasn't going to let the rain stop me from installing them though.
It took about 3 hours to install - but most of that time was double and triple checking pinouts for the plugs. If I were to do it again, I could probably knock it out in about 2 hours.
It took about 3 hours to install - but most of that time was double and triple checking pinouts for the plugs. If I were to do it again, I could probably knock it out in about 2 hours.
The following users liked this post:
ttribe (12-21-2018)
#5069
GO RANGERS!!!!!!!!!!!!!!!
iTrader: (6)
Dynamic taillights arrived yesterday, even though they've been in the states since Dec 7th I wasn't going to let the rain stop me from installing them though.
https://youtu.be/wtKRkZnpGkk
It took about 3 hours to install - but most of that time was double and triple checking pinouts for the plugs. If I were to do it again, I could probably knock it out in about 2 hours.
https://youtu.be/wtKRkZnpGkk
It took about 3 hours to install - but most of that time was double and triple checking pinouts for the plugs. If I were to do it again, I could probably knock it out in about 2 hours.
Pretty damn cool.
VW/Audi gives great light.
The following users liked this post:
civicdrivr (12-20-2018)
The following users liked this post:
civicdrivr (12-21-2018)
#5071
Moderator
iTrader: (3)
So. Many. Lights.
The following 2 users liked this post by CLtotheTL32:
civicdrivr (12-21-2018),
rockstar143 (12-26-2018)
#5072
Whats up with RDX owners?
Thread Starter
iTrader: (9)
Today ended up being 65* and sunny, so I decided to wash the car and make some mudflaps. They're some universal Rally Armor flaps that I was going to use on the FR-S when I went with the RB kit (which obviously never happened), and they've been sitting on a shelf for 3 years. A little trimming to get the right shape, and they look decent.
I'm in love with these lights.
And that will probably be the first and last wash of the winter
I'm in love with these lights.
And that will probably be the first and last wash of the winter
The following 3 users liked this post by civicdrivr:
#5074
Whats up with RDX owners?
Thread Starter
iTrader: (9)
#5075
Moderator
iTrader: (3)
So fresh and so clean clean
The offset front plate is killing me. Is there no option for a centered factory mount?
The offset front plate is killing me. Is there no option for a centered factory mount?
#5076
GO RANGERS!!!!!!!!!!!!!!!
iTrader: (6)
Do the mudflaps have Yosemite Sam on them?
#5077
Whats up with RDX owners?
Thread Starter
iTrader: (9)
Unfortunately, the OEM option requires drilling into the face of the bumper:
And mounting the plate in the middle in the lower grill will block airflow into the intercooler. I'm still hoping VA drops the front plate, but as long as the State Police sit on the transportation committee, that won't happen.
No, Mudflap Girl
#5078
Your Friendly Canadian
Join Date: Dec 2007
Location: Toronto, Ontario
Age: 31
Posts: 17,428
Received 1,484 Likes
on
1,048 Posts
My gosh when did you clowns get so old!? Can't drive in the snow, offset license plate mounts
#5079
Ex-OEM King
I got mine permanently installed. No chance of MN dropping the front plate law and my OCD won't allow the offset mount lol.
How the F did you go from 11" of snow to 65? That sounds awesome!
How the F did you go from 11" of snow to 65? That sounds awesome!