My old busted AEM intake pipe w/ vibramount (3G TL)
#1
My old busted AEM intake pipe w/ vibramount (3G TL)
As some of you may know, the vibramount arm from my AEM intake sheared off a while back. I finally got it replaced with a new pipe, so my old one is up for sale.
As you can see from the pics, the tear was a clean one, and the buyer can either do one of the following:
-Re-weld the vibramount arm back on.
-Just put a massive amount of duct tape over the hole and run the intake like that. That's what I have been doing for the past three weeks and I had 0 problems.
Also, I cut off 3/4 inch from the end of the pipe to accomodate my throttle body spacer, but it will work fine with or without one.
Included is the pipe, vibramount arm, and actual rubber vibramount with nuts and washer.
$50 shipped.
No dibs, my paypal is ahumanbeingebay@gmail.com. First to paypal the funds takes it. If I haven't updated this thread with SOLD, it is still available.
As you can see from the pics, the tear was a clean one, and the buyer can either do one of the following:
-Re-weld the vibramount arm back on.
-Just put a massive amount of duct tape over the hole and run the intake like that. That's what I have been doing for the past three weeks and I had 0 problems.
Also, I cut off 3/4 inch from the end of the pipe to accomodate my throttle body spacer, but it will work fine with or without one.
Included is the pipe, vibramount arm, and actual rubber vibramount with nuts and washer.
$50 shipped.
No dibs, my paypal is ahumanbeingebay@gmail.com. First to paypal the funds takes it. If I haven't updated this thread with SOLD, it is still available.
Thread
Thread Starter
Forum
Replies
Last Post
rp_guy
Member Cars for Sale
9
07-16-2017 07:33 AM