Question on my Mercman harness
#1
Question on my Mercman harness
I have a 2006 TSX w/ navi and a mercman harness with a Balun
The signal is fed into an alpine pdx 4.100 and an 1.1000
Now the 1000 has setting for the input to be ".1-1v" and "1v-10v"
Where should it be set? If i have it set to .1.-1v it is obviously louder and with the gain set low it sounds good.
With it set to 1v-10v it definately is quieter, but i can turn the gains up quite a bit.
i prefer the .1-1v switch with gaines at like 20%, but want to make sure this is right/not hurting anything.
Thanks
The signal is fed into an alpine pdx 4.100 and an 1.1000
Now the 1000 has setting for the input to be ".1-1v" and "1v-10v"
Where should it be set? If i have it set to .1.-1v it is obviously louder and with the gain set low it sounds good.
With it set to 1v-10v it definately is quieter, but i can turn the gains up quite a bit.
i prefer the .1-1v switch with gaines at like 20%, but want to make sure this is right/not hurting anything.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
navtool.com
5G TLX Audio, Bluetooth, Electronics & Navigation
31
11-16-2015 08:30 PM
navtool.com
1G RDX Audio, Bluetooth, Electronics & Navigation
1
09-25-2015 05:15 PM