How to use the 2nd video input on Tv and Nav 2 Go module?
#1
How to use the 2nd video input on Tv and Nav 2 Go module?
I have a 2005 TSX with navi and bought the TVandNav2Go module.
I was able to hook up my backup camera on the 1st video input.
For the 2nd video input it's asking me to connect the green wire to the handbrake. Is there a way for you not to set your handbrake on and be able to watch video while driving? I would like to have this going through a switch or some sort and by flipping that switch on, it will override Video 1 and the navigation map screen.
Someone must have done this, please with the instructions or what I might need to buy extra to make this working.
Thanks!
Tuon
I was able to hook up my backup camera on the 1st video input.
For the 2nd video input it's asking me to connect the green wire to the handbrake. Is there a way for you not to set your handbrake on and be able to watch video while driving? I would like to have this going through a switch or some sort and by flipping that switch on, it will override Video 1 and the navigation map screen.
Someone must have done this, please with the instructions or what I might need to buy extra to make this working.
Thanks!
Tuon
#3
Senior Moderator
you can ground it anywhere and use the switch provided to switch from the nav back to the input source.
Thread
Thread Starter
Forum
Replies
Last Post
navtool.com
5G TLX Audio, Bluetooth, Electronics & Navigation
31
11-16-2015 08:30 PM
navtool.com
1G RDX Audio, Bluetooth, Electronics & Navigation
1
09-25-2015 05:15 PM