Tein street basis coilovers help
#1
2nd Gear
Thread Starter
Join Date: Oct 2017
Location: Atlanta
Age: 26
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Tein street basis coilovers help
Okay, I've assembled my coilovers, however something does not seem right. The metal ring piece that goes in the rubber part that sits inside the mount isn't staying in on the front pieces. There is about an inch or so gap between the mount and the spring. The metal piece I'm talking about is just sitting on top of the spring rather than in the rubber piece like it is supposed to. Is this because I need to have them compressed since they were not pre-assembled? I'm switching over from A-spec and I installed them myself and no issues. Picture of the car below. I can post pictures of the coil overs and what exactly I'm not understanding if I wasn't clear enough in my message.