Hey guys,

Just wondering if there's a guide to remove the license plate assembly.

I do know I have to remove the trunk liner, which I've done before to install LED license plate lights.

Is it as easy as just removing the trunk liner, and unscrewing some bolts that hold the license plate assembly?

Thanks!

 

E-034: DIY:Removing aluminum strip above rear license plate & trunk liner?https://acurazine.com/forums/showthread.php?t=84489




Bookmark this link: https://acurazine.com/forums/3g-tl-2004-2008-93/3g-tl-garage-faq-3g-tl-newbies-553554/

 

Thanks, man.

Greatly appreciated =)

 

Ah shitty, I just removed the trim fine, except I broke off two bolts (one on each side, at the bottom).

I should be okay with the clips, and 2 top bolts holding the trim, right?

 

You might be alright but I would think that it would rattle a little bit.