njtls

the good news is i finally got my exhaust to hang evenly on both sides

njtls

the bad news is.... i think my bodykit is melting....

njtls

what do you think i should do...do you think it will spread...if it doesnt..it wont bother me cause you cant see it...i know i have to extend it...but i dont have the time to right now...or the money...i was thinking of covering it with tin foil...do you think that would help it?...for now atleast?

songoku

It might sounds too funny for you since I don't know what the deal was, but can you just lower both side a little bit low?

fsttyms1

tinfoil wont last/help. is the end of the exhaust pipe ending under(infront of) the ground effect?

fsttyms1

i would check with a muffler shop and see how much they want to extend the mufflers.

njtls

i dont know how i would beable to get it lower...plus i like the look of it that high....

the exhaust ends before the kit...i would need to get it extended quite a bit...i just dont understnad how it would hang..i would probal yhave to move the hangars aswell...im not sure if i want them cutting a welding on my actual mufflers..if i didnt have to move the hangars..i could just extend it myself....i duno..i gues i have to measure some more

shimbo519

i have the same problem with my comptech's. every time i hit a bump in the road, the comptechs move and cause my kit to melt upon touching it. Not tooo noticeable unless u look from underneath the car.

bigmonkey70

You might be able to get it a little lower witha a bigger rubber hanger (the rubber piece that hold the muffler hanger to the chassis).

bigman

extend it a little past the bumper. My exhaust is closer to my skirt than yours is and it hasnt melted anything.

njtls

yeah...i cant figure out exactly how and wher to do it...i dont want to have to change the hangars and everything...i dont want them to mess it up and have it hang un evenly or anything...anyone wan tto tell me how they did it?

drcookie

Can you make/change/swap/mod the tips a little smaller ? I know it won't look good but I think it might help.

Cheers !!!

bigman

any reputable exhaust shop will be able to extend the piping and replace the hanger points without messing anything up. Its either that or a $500 repair job for your bumper.