Tomtwtwtw

Did it come with a separate screw for the MAP sensor that plugs into the corner of the IC? I'm talking about the little 8mm screw, not any of the 10mm.

Thanks~

Tomtwtwtw

Or some kind of gasket or o-ring for the recirc valve?

Tomtwtwtw

So it turns out the MAP sensor bolt hole on the ETS IC fits the same size as the rest of the bolts that hold it in place, so I just went and got the correct length / size bolt from Ace for 60 cents.

For another 60 cents I bought a large, flat rubber washer and trimmed it to fit between the recirc valve and IC. I just don't trust a metal to metal connection to hold pressure. Maybe it's just me?

Still not sure if the IC comes with these two things normally, but just in case I figured I'd post up my cheap and easy solution.