Alignment problems
02-06-2002, 04:35 PM
#1
Time to POWER UP!!
Thread Starter
Alignment problems
Went to get my car aligned today and my rear camber was 4.2 degree off. From what i heard (at diff stores) there in no camber kit for our car, only a adjustable control arm (lowest price was $130 each). Anyone have a camber problem after installing springs? If so what did you do to fix the problem?
02-07-2002, 04:31 PM
#3
Cost Drivers!!!!
There is a camber correction kit for the rear but not for the front. Check out www.autocarparts.com
Some people have had to get a camber kit and others have not.
Some people have had to get a camber kit and others have not.
02-07-2002, 05:08 PM
#4
Burning Brakes
Join Date: Mar 2001
Location: Austin, TX
Age: 53
Posts: 1,131
Likes: 0
Received 0 Likes
on
0 Posts
I had to get the camber kit... it is made by Specialty Products I think.
I chewed through a set of Pirelli's in 6 months without it.
ACP has the rear kit for 175 or so I think...
I chewed through a set of Pirelli's in 6 months without it.
ACP has the rear kit for 175 or so I think...
02-07-2002, 07:02 PM
#5
4.2 degrees wow that car must be lowered quite a bit.the worst I have seen is 1.1 degrees beyond allowable limits what type of springs were installed.Comptech carries camber correction kits but I am not sure if they will correct that amount.Jens
02-07-2002, 07:06 PM
#6
Suzuka Master
Originally posted by Jens Heydel
4.2 degrees wow that car must be lowered quite a bit.the worst I have seen is 1.1 degrees beyond allowable limits what type of springs were installed.Comptech carries camber correction kits but I am not sure if they will correct that amount.Jens
4.2 degrees wow that car must be lowered quite a bit.the worst I have seen is 1.1 degrees beyond allowable limits what type of springs were installed.Comptech carries camber correction kits but I am not sure if they will correct that amount.Jens
Could a suspension piece be bent????
Thread
Thread Starter
Forum
Replies
Last Post
SidhuSaaB
3G TL Problems & Fixes
18
05-30-2020 12:40 AM
