Dash Lights Do Not Work AFTER HU Installation

Old 04-21-2009, 06:32 PM
  #1  
6th Gear
Thread Starter
 
prothanh4's Avatar
 
Join Date: Apr 2009
Age: 37
Posts: 6
Likes: 0
Received 0 Likes on 0 Posts
Dash Lights Do Not Work AFTER HU Installation

So a HU was installed in my car and now my instrument cluster lights as well as my dash lights do not work. All the fuses are good I checked panels as well as under the hood. I took apart the dash and found out that a wire harness was not used and the guys just cut and spliced all my wires. I narrowed it down and the LIGHTS ON SIGNAL and the DASH LIGHT BRIGHTNESS CONTROLLER needs to be connected to something and its not. So does anyone know what i should do??? ANY SUGGESTIONS is better than driving in the dark.
Old 04-21-2009, 06:37 PM
  #2  
Senior Moderator
 
fsttyms1's Avatar
 
Join Date: Aug 2002
Location: Appleton WI
Age: 49
Posts: 81,383
Received 3,063 Likes on 2,119 Posts
It shoundt have to be connected. Sounds like something isnt connected correctly.
Old 04-21-2009, 06:46 PM
  #3  
6th Gear
Thread Starter
 
prothanh4's Avatar
 
Join Date: Apr 2009
Age: 37
Posts: 6
Likes: 0
Received 0 Likes on 0 Posts
but when i turned on the headlights there is power going to those wires and when the headlights are off those wires go to ground
Old 04-21-2009, 07:05 PM
  #4  
Pro
iTrader: (3)
 
juanclopez2786's Avatar
 
Join Date: Mar 2008
Location: jersey
Age: 37
Posts: 653
Likes: 0
Received 3 Likes on 3 Posts
is the dimmer switch working? disconnect the dimmer switch, when your looking at the plug its a 6 pin connector 123456 check resistance between 4 and 5. it should be between 0-20k ohms when you adjust the knob.
Old 04-21-2009, 07:48 PM
  #5  
6th Gear
Thread Starter
 
prothanh4's Avatar
 
Join Date: Apr 2009
Age: 37
Posts: 6
Likes: 0
Received 0 Likes on 0 Posts
im really new when it comes to my TL but how am I suppose to do that
Old 04-21-2009, 09:15 PM
  #6  
Pro
iTrader: (3)
 
juanclopez2786's Avatar
 
Join Date: Mar 2008
Location: jersey
Age: 37
Posts: 653
Likes: 0
Received 3 Likes on 3 Posts
do you know how to use a digital volt ohm meter?
Old 04-21-2009, 10:34 PM
  #7  
6th Gear
Thread Starter
 
prothanh4's Avatar
 
Join Date: Apr 2009
Age: 37
Posts: 6
Likes: 0
Received 0 Likes on 0 Posts
yea, ok ill check that in the morning. hypothetically speaking what if it's not the dimmer switch where do i go from there. does it have anything to do with the LIGHTS ON SIGNAL and the DASH LIGHT BRIGHTNESS CONTROLLER wires?? they are getting power when the headlights are turned on and off when the headlights are off. should i just cap those off or are they suppose to be connect somewhere??
Old 04-22-2009, 06:35 AM
  #8  
Senior Moderator
 
fsttyms1's Avatar
 
Join Date: Aug 2002
Location: Appleton WI
Age: 49
Posts: 81,383
Received 3,063 Likes on 2,119 Posts
Those wires dont need to be connected. My lights worked when it was disconnected. I still think something is hooked up wrong. Who did the install? Id bring it back to them.
Old 04-22-2009, 10:41 AM
  #9  
Drifting
 
totaledTL's Avatar
 
Join Date: Apr 2008
Location: Louisville, KY
Age: 61
Posts: 2,348
Received 33 Likes on 29 Posts
^ Agree- why don't you take it back to the installer & ask them to recheck it if it worked before the installation?
Old 04-22-2009, 04:07 PM
  #10  
6th Gear
Thread Starter
 
prothanh4's Avatar
 
Join Date: Apr 2009
Age: 37
Posts: 6
Likes: 0
Received 0 Likes on 0 Posts
ok i took a voltmeter to the dimmer switch and its working fine. i checked all the wires and capped off those two wires. The lights worked fine before the HU. i'm kinda out of ideas.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
mada51589
3G TL Problems & Fixes
79
05-03-2022 08:54 PM
Yumcha
Automotive News
9
02-25-2020 09:57 AM
wusty23jd
3G TL Audio, Bluetooth, Electronics & Navigation
4
09-24-2015 11:41 AM
drewdeezy03
3G TL Problems & Fixes
2
09-03-2015 08:04 PM
prox
5G TLX Problems & Fixes
6
09-01-2015 02:03 AM


Thread Tools
Search this Thread
Quick Reply: Dash Lights Do Not Work AFTER HU Installation



All times are GMT -5. The time now is 05:43 PM.