Will these headers fit
#1
Will these headers fit
I just picked up a 2-3 month old set of xs power headers. But when I compare the rear bend to other xs power header it looks smaller. How big does the bend have to be to clear CLS 6 speed rear motor mount?
Here is a pic of what i bought
Here is a pic of what i bought
#2
Racer
The bend in mine was similar, maybe even a little more bent (slightly), and I had to remove the motor mount to install mine.
Let me know how your install goes!
Let me know how your install goes!
#3
lowrd on tein CS biatch
iTrader: (2)
Iirc the bend in those looks to be a little off.
The header bend is usually a little higher up and more pronounced as the bend occurs over a shorter distance on the comptech headers I have seen.
But that's not to say those will not work. But I think it's going to be very tight
The header bend is usually a little higher up and more pronounced as the bend occurs over a shorter distance on the comptech headers I have seen.
But that's not to say those will not work. But I think it's going to be very tight
#6
I noticed the same thing when I saw picture of the headers. I read on a thread of a member grinding the mount down to fit auto headers. looks like he only grinded 5-10mm. I think the bend should clear that. Hopefully I can get them to fit.
Another question what o ring gaskets did you guys use?
Another question what o ring gaskets did you guys use?
#7
M90booosted
i used the rings that came with my xs power. so far they are ok. the front flanges arent lined up very well. i had to notch the front subframe so it wouldnt rub.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
rp_guy
Member Cars for Sale
9
07-16-2017 07:33 AM