low97accord

hey everybody. names Phil. i drive an accrord coupe (we are like sisters! lol) and im tryign to wire these seats into my car. got everything bolted up all secure i just dont know how to wire them up...does anybody have this? ive been searching all over for one with no luck.

nspec_ya4

iTrader: (38)

i'll see if i can scan it and post it up for u. give me some time

nspec_ya4

iTrader: (38)

I looked through what i had on the computer this is the only thing i could find on the power seat wiring.

low97accord

thanks. ill save it and give it a look. i figured out the pass seat pretty easy. the driver seat is a diff story, especially since the plug was cut sighhhh... luckly i was able to jump the harness and atleast set the chair to a comfortable position lol

nspec_ya4

iTrader: (38)

even better info. I was looking at the service manual

Grn/Yel and Grn = front motor up/down
Blu/Yel and Blu = slide motor
Red/Yel and Red = Rear motor up/down
Yel/Grn and Yel = Recline Motor


On the diagram, it looks like ur really just need to power the Blue and Red wires and ground the black ones on the connector. I think the seat belt sensor wires should be the same.


Passenger Side

Blu/Yel and Blu = Slide motor
Yel/Grn and Yel = Recline Motor

You will probably need to setup some relays to make the motors work with the factory switch if you are not using the factory power seat control unit on the passenger side.


*** got this info off of a 01 setup but it should be pretty much the same.

low97accord

thanks ill give it at look today and see if that works. i appreciate it a lot man

chtrcy

Nspec...You da man!

nspec_ya4

iTrader: (38)

no problem. Charles, i thought urs was an 01?