Power to Passenger headlight 98 Cl 3.0
02-08-2016, 06:24 PM
#1
1st Gear
Thread Starter
Join Date: Feb 2016
Age: 49
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Power to Passenger headlight 98 Cl 3.0
Hey everyone my daughters car (98 Cl 3.0) is having a passenger headlight issue.
Previously the headlight was out, so I pulled the bulb and it looked fine so I reinstalled it and the light came back on right away.
That was a few months ago, and light is out again. I pulled the bulb and checked it with my multimeter it checked out good, then I made a pigtail and hooked it up to the battery(pos & neg side) again bulb lit up. When testing the socket I get power at both wires, shouldn't one side be a ground? just for the hell of it I took the connector apart and made sure the pins were tight and fully seated. Everything checks out, except power on both wires going into the connector.
Thank for the help
Previously the headlight was out, so I pulled the bulb and it looked fine so I reinstalled it and the light came back on right away.
That was a few months ago, and light is out again. I pulled the bulb and checked it with my multimeter it checked out good, then I made a pigtail and hooked it up to the battery(pos & neg side) again bulb lit up. When testing the socket I get power at both wires, shouldn't one side be a ground? just for the hell of it I took the connector apart and made sure the pins were tight and fully seated. Everything checks out, except power on both wires going into the connector.
Thank for the help
Thread
Thread Starter
Forum
Replies
Last Post