Mine was 03 I believe. 01-02 will fit. Installation was simple. There's a DIY listed in the DiY section but it's pretty straightforward. Disconnect negative battery cable and let sit for 15 mins to avoid discharging airbag first. Then on either side of the wheel in middle is a small removable panel. Gently pry them out. There's a T30 torx screw either side to remove. Another small panel under the wheel comes off gently and there's a connector down there to unclip then squeeze the tab and disconnect it. Now carefully slide airbag forward and disconnect the second harness from it. On the left radio controls is 2 harnesses to remove then one on the right for cruise. Then remove the black counter balance weight from the top. After that the white wire holder. That should cover the disassembly of it all. Now just make a note of where the old wheel is positioned (I locked mine to avoid problems) then wiggle old wheel off. Install the opposite way u took it all apart. Fairly simple. I snapped a pic after the airbag was forward to make sure I got it back together correctly. I jus typed this from memory and I'm pretty sure I covered it all but check the DIY just in case I missed something.
