trackvaulter01

Advanced

About Me

  • About trackvaulter01
    Location
    Buffalo/NYC
  • Signature
    2001 Acura Cl Type S, Suzuki GS500F
    AEM CAI-20% tint-debadged-Blazer Projector Fogs 3000k-Full Red LED Conversion-Kenwood Excelon DNX6980-Stoptech slotted rotors and pads-Morimoto Mini H1 bi-xenon projectors, 6000k bulbs, cleared, gunmetal painted housing/low beam reflector, switchback turn signals-

Statistics

Total Posts
Albums
Visitor Messages
Total Likes
General Information
  • Last Activity: Apr 9, 2015 08:44 PM
  • Join Date: Oct 28, 2009
  • Referrals: 0

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. KatabaticSaint
    Dec 11, 2009 09:22 AM - permalink
    Yeah Just about. What I did though is I wired it from the led connected it to the 18 guage mark one with like a solid black strip and a dotted one or something to distinguish them. That will make it easier. But i wired it from the led to to a switch to the fuse box (cuz cops round here dont like LED's in the car so if i got pulled over i could easily turn them off) there shouldn't be a - though most led's are just a + and ground so you take the wire up to your switch and then take an outbound wire towards the fuse box so when you open your door fully since it is a cl it should be similar the fuse box is right on the side of the dash and you just pull out the plastic cover. Take out a fuse using pliars be gentleish cuz it will take force to get it out. and then just put the wire in between the prongs and put it back in and as for grounding there are screws all along the area around the fuse box i think cuz i have a tl just un do the screw place the wire in it tighten up the screw and wire it in place then hide all the wires under the floor mats and stuff them into the plastic. also if you need help getting from the passenger side to the switch you have a hole down near the gas pedal run the wire through there using a coat hanger.. but be gentle good luck

All times are GMT -5. The time now is 12:11 PM.