Supercharger Pulley Drive Extension
08-10-2015, 08:43 PM
#1
Senior Moderator
Thread Starter
Supercharger Pulley Drive Extension
A friend and I are working on a project for a weekend race car and we encountered an issue with the setup he wants to run.
We have been looking for a custom drive shaft extension like what is used to extend the pulley over to the other side of the engine bay.
Is it as simple as a balanced shaft with custom machined ends to fit the rotrex or s/c & pulley with bearings and supports?
from acura TL comptech S/C:
We have been looking for a custom drive shaft extension like what is used to extend the pulley over to the other side of the engine bay.
Is it as simple as a balanced shaft with custom machined ends to fit the rotrex or s/c & pulley with bearings and supports?
from acura TL comptech S/C:
08-29-2015, 12:21 AM
#2
Senior Moderator
Thread Starter
bump
09-04-2015, 11:53 AM
#3
Senior Moderator
The ones i have seen have been nothing more than a shaft inside a tube (safety) with either bearings at both ends, or at one end and a plate/drive to bolt to or turn the SC pulley.
The following users liked this post:
csmeance (09-04-2015)
Thread
Thread Starter
Forum
Replies
Last Post
Yumcha
Automotive News
2
09-04-2015 08:03 AM